Roland V-combo VR-09 User Manual

37
Using the Looper
The looper is a function that lets you overdub while recording and playing back in real time.
You can take advantage of various performance possibilities, such as performing or adjusting the eects while playing back recorded phrases as a
backing.
* The maximum recording time is approximately 20 seconds.
Recording with the Looper
MEMO
Steps indicated by
can also be performed using a pedal switch (DP-2; sold separately) connected to the DAMPER jack or EXPRESSION PEDAL
jack.
If you want to use a pedal switch to operate the looper, set Damper Assign (p. 45) or Expression Assign (p. 46) to “LOOPER.”
Record-standby
Press the [LOOPER] button to enter
the record-standby condition.
Recording
Recording will begin immediately
when you press the [
] (START/
STOP) button or play the keyboard.
Loop playback
Play back a loop.
Press the [
] (REC) button to switch
to overdubbing.
Overdubbing
Record by layering your performance
onto the loop playback.
Press the [
] (REC) button to switch
to loop playback.
Stop
During loop playback or overdubbing,
press the [
] (START/STOP)
button to stop.
* If you’re using the pedal switch, press
it twice within one second.
Save
If you press the [LOOPER] button while stopped,
the SAVE LOOPER screen appears.
REFERENCE
For more about saving phrases, refer to
“Saving a Phrase” (p. 38).
Save
Exit
Press twice
Press twice
Introduction Performing Recording Looper Settings
Appendix

Roland V-combo VR-09 Specifications

General

Equalizer	Yes
Product type	Digital synthesizer
Product color	Black
Sound effects	Compression, Delay, Overdrive, Reverberation
Sound effects quantity	223
Keyboard number of keys	61
Maximum polyphony (notes)	128
Reverberation effects quantity	6
Headphone outputs	1
6.35 mm (1⁄4-inch) output	2
Battery type	AA
Operating time	5 h
Power source type	AC, Battery
Number of batteries supported	8

Weight and Dimensions

Depth	300 mm
Width	1008 mm
Height	106 mm
Weight	5500 g