EDITING VIDEO CLIPS
You can cut a video clip at a desired point and save it from the beginning to
that point as a separate video clip, or save from that point to the end as a
separate video clip (“clipping”).
You can also join two video clips together and save them as one separate clip
(“joining”).
NOTE
Caution when editing video clips
œ When editing video clips, do not move the main switch. If you move the
main switch while editing video clips, not only will the editing not be
properly completed, but the original video clip may also be erased.
œ By repeating the clipping and joining procedures, you can create exactly
the video clip you like. Note, however, that as the number or size of the
video clips increases, the card memory may become full, making it
impossible to edit the video clips. (The “MEMORY FULL” message will
appear.) In this case, you will need to free some of the memory on the card
either by deleting data that are no longer necessary [page 157], or by
performing the procedure to erase the original video clip(s) [page 144].
SX215/EX, U (VPC-MZ2 GB) Mon. March 25/2002
English
141
To Next Page
Loading...
Need help?
General
