CHECKING THE REMAINING CARD MEMORY
You can check how many images can be captured and how much recording
time is available on the card. For a table showing the maximum number of
images and recording time for specific cards, please see “Possible No. of
Images/Possible Shooting Time/Possible Recording Time” on page 201.
Checking the remaining number of images
and video recording time
1
Set the main switch to [Õ], and
press the power button.
œ Set the selector dial to anything
other than [P] or [Ü ].
œ The remaining number of images
appears in the upper right of the
LCD monitor (for the still image and
sequential shots shooting modes).
œ The remaining video recording time
appears in the upper right of the
LCD monitor (for the video clip
shooting mode).
œ The remaining number of images
and video recording time will differ
depending on the resolution and
compression settings.
œ When the remaining number of
images or the remaining time of
video clips that can be taken is “0”,
you cannot capture any more
images. To capture more images,
either install a new card, or save the
current images (see page 160) and
then erase them (see page 157)
from the card.
<Still image shooting mode>
Power
button
Main switch
Selector dial
MONITOR OFF
13
3.1
1/50
Remaining number of
images possible
SX215/EX, U (VPC-MZ2 GB) Mon. March 25/2002
English
176
To Next Page
Loading...
Need help?
General
