USING THE AUTOFOCUS
The autofocus will work in almost all situations; however, there are certain
conditions that may cause the autofocus function to not work properly. If the
autofocus function is not working properly, use the manual focus mode to
capture images.
B Conditions that may cause incorrect focus
The following examples are some of the situations where the autofocus
function may not work.
œ Subjects with low contrast, very bright
subjects at the center of the image, or
dark subjects or locations
Use the focus-lock function (see page
58) to lock the focus on a subject with
contrast at the same distance as the
desired subject.
œ Subjects without vertical lines
Use the focus-lock function to lock the
focus on the subject while holding the
digital camera vertically.
The following examples are some of the situations where the autofocus
function may work, but not as desired.
œ When both near and far objects are
present
Use the focus-lock function to lock the
focus on a subject at the same distance
as the desired subject.
SX215/EX, U (VPC-MZ2 GB) Mon. March 25/2002
English
54
To Next Page
Loading...
Need help?
General
