ASSIGNING FILE NAMES
If a reformatted card is used, the file name (image number) of the captured
image automatically begins from 0001. If the card is subsequently
reformatted, or if a different reformatted card is used, the file names again
begin from 0001. This is because the file number reset function is set to ON,
and consequently it results in more than one card containing images with the
same numbers. By setting the file number reset function to OFF, even if the
card is reformatted or the card is replaced with another card, the consecutive
numbering of file names continues from the last number recorded by the
camera.
<File number reset function ON>
<File number reset function OFF>
œ If Card B already has image data in it when it replaces Card A, file names
are assigned as follows.
œ
When the highest image number on Card B (before replacing) is lower
than the highest image number on Card A: the file name of the next
recorded image continues from last file name recorded on Card A.
File name (image number)
Card A
Card B
0001, 0002
0001, 0002
0012, 0013
0012, 0013
Replace card
File name (image number)
Card A
Card B
0001, 0002
0014, 0015
0012, 0013
0025, 0026
Replace card
Previously recorded images
Card A 0001, 0002 0012, 0013
0001, 0002, 0014, 0015 0025, 0026Card B
Replace card
SX215/EX, U (VPC-MZ2 GB) Mon. March 25/2002
English
170
To Next Page
Loading...
Need help?
General
