7
7 PRECAUTIONS WHEN MOVING THE MACHINE
• When moving the cabinet, do not grip or push the Billboard Plate. Doing so
could deform or damage the part.
• When moving the cabinet, do not grip or push the HOOPS. Doing so could
deform or damage the part.
• When moving the cabinet, do not grip or push the Controller. Doing so could
deform or damage the part.
• If moving through a door or place with a low ceiling such as an elevator, you
should take apart the billboard and billboard plate.
• Always disconnect the power cable before moving the product. If it is moved
with the power cable connected, the cable could be damaged, causing fi re
or electric shock.
• To move the unit over the floor, pull in the adjustors and have the casters
contact the floor. Remove the CABINET LOWER BRACKETS. While moving the
unit, be careful that the casters do not roll over the power cord or the ground
wire. If cord or wire is damaged, there could be electrical shocks and/or short
circuits.
• When crossing a sloped or stepped area, always have the machine travel
lengthways with the screen towards the slope. Travelling with the machine
in a sideways position could result in the machine falling over onto its side.
Always use a minimum of two people working together plus lifting apparatus
to accommodate slopped areas or stairs.
• To lift up the cabinet, hold it at the bottom at the designated lifting points. If you
hold it anywhere else, the weight of the cabinet could cause damage to parts
or attachments, resulting in injury.
• Do not push the cabinet from the side when moving. Pushing from the side as it
may result in the cabinet falling over.
To Next Page
Loading...
Need help?
General
