26
REPLACING SUPPLIES AND MAINTENANCE
Replacing the drum cartridge
Your service technician will replace the drum cartridge. Only replace the
cartridge as explained below if your service technician instructs you to. Follow
the instructions carefully.
• Do not leave the drum cartridge outside of its package for a long time, and do
not remove cartridge from its package in a location where there is bright
sunlight or bright light. This may cause a failure.
• When you remove a drum cartridge, place it in a dark location and do not
allow light to shine on the cartridge.
1
Turn off the power and remove the developer cartridge.
For the procedure for removing the developer cartridge, see steps 1 to 4 of
"Replacing the developer cartridge" (page 18).
To remove the drum cartridge, the developer cartridge must first be
removed.
2
Hold down the lever on the drum cartridge with
your finger and pull the drum cartridge toward you.
Place one hand at the middle of the drum cartridge and pull out with both hands.
Do not touch toner on the old drum cartridge. If you accidentally touch
the toner, immediately wash your hands.
Developer cartridge
Drum cartridge
mxc401_us_saf.book 26 ページ ２００８年１０月１５日 水曜日 午前１１時５２分
To Next Page
Loading...
Need help?
General
