7-83
SYSTEM SETTINGS
Contents
Color Data Compression Ratio
Setting
[Low], [Medium], or [High] can be selected for the default
compression ratio for transmission of a stored color file.
Scan Complete Sound Setting
This setting adjusts the volume of the beep that sounds
when scanning ends. The beep can also be turned off.
Disable Stamp for Reprinting
When a stored file is retrieved and printed, this setting
prohibits the selection of a "Stamp" setting in the special
modes. If a stamp setting is already selected, it will not
be possible to change the stamp setting.
This function can be used to prevent inconsistencies in
the printed information, such as that of the original date
in the file and the date the file is retrieved and printed.
Batch Print Settings
When printing files by batch printing, this setting is used
to prohibit the selection of the [All Users] key and the
[User Unknown] key in the user selection screen.
Erase Width Adjustment
This is used to set the default erase width for erase
function. Specify a value from 0" (0 mm) to 1" (20 mm) in
increments of 1/8" (1 mm) for edge erase.
Card Shot Settings
This is used to set the default original size for the card
shot function.
Both the X (horizontal) and Y (vertical) dimensions of the
original can be set from 1" (25 mm) to 8-1/2" (210 mm) in
increments of 1/8" (1 mm).
Fit to Page
Enable this setting to have the [Fit to Page] key always
appear in the card shot screen.
To Next Page
Loading...
Need help?
General
