Remote-SAT User's Guide
P R E L I M I N A R Y
MC35_SAT_01_V01.01a - Preliminary Page 22 of 64 15.11.2001
1.4 AT^SSTGI Remote-SAT Get Information
1.4.1 AT^SSTGI Remote-SAT Get Information – Generic Format
Test command
AT^SSTGI=?
Response
^SSTGI:(list of supported <state>s), (list of supported <cmdType>s)
OK
Read command
AT^SSTGI?
Response
^SSTGI: <state>, <cmdType>
OK
Parameters
<state> Remote-SAT interface states (refer to AT^SSTA)
<cmdType> Ongoing Proactive Command (values see chapter 1.1.4
“Command Type Values”.). However, this information is valid
during states PAC and WAIT only.
Write command
AT^SSTGI=
<cmdType>
There are two situations for use of the Write command:
1. Regularly the Write command is used upon receipt of an unsolicited result
code ^SSTN:<cmdType>.
In this case the TA is expected to acknowledge the ^SSTGI response with
AT^SSTR to confirm that the proactive command has been executed.
AT^SSTR will also provide any user information e.g. selected menu item.
2. There may be the situation to request the information via AT^SSTGI without
previously receiving an URC ^SSTN:<cmdType>.
This will always be the case if the TA has started or restarted its application
(e.g. a MMI) after power on the ME.
To request the information despite the probably missed URCs it is possible
to issue AT^SSTGI during states IDLE, PAC and WAIT at any time for the
following Proactive Commands:
PAC type 5: Set Up Event List,
PAC type 37: Setup Menu,
PAC type 40: Setup Idle Mode Test.
Note:
In case of using the Write command without receipt of an unsolicited result
code ^SSTN:<cmdType> it is neither necessary nor possible to
acknowledge the ^SSTGI response with AT^SSTR.
Such a ^SSTGI response will not cause any state changes.
The command type value is returned to the ME to identify which ^SSTN is being
responded to.
Reference
Siemens
Note
To Next Page
Loading...
Need help?
General
