Remote-SAT User's Guide
P R E L I M I N A R Y
MC35_SAT_01_V01.01a - Preliminary Page 38 of 64 15.11.2001
bits 2-8: = RFU
<titleIconId> 0-255, 0: no icon
<numOfItems> Number of menu items in the list
<itemId> Menu item identifier (1 – numOfItems)
<itemText> Title of menu item
<nextActionId> The next proactive command type to be issued upon
execution of the menu item. See Table 1
0: No next action information available.
<iconId> 0-255, 0: no icon
Reference
Siemens
Note
It is possible to issue AT^SSTGI during states IDLE, PAC and WAIT for this
Proactive Command without previously receiving an URC ^SSTN:<cmdType>,
see section “AT^SSTGI Remote-SAT Get Information – Generic Format”, pg.
22.
1.4.15 AT^SSTGI Remote-SAT Get Information – Setup Idle Mode Text (40)
Write command
AT^SSTGI=40
This command is mainly to be used upon receiving an unsolicited result code
^SSTN:40. However, please refer to note below.
It provides text, and optionally an icon, to be displayed by the TA when the
display is Idle.
Response
^SSTGI: <cmdType>, <commandDetails>, <text>, <iconQualifier>, <iconId>
<CR> <LF>
Parameters
<cmdType> 40 – Proactive command ID, see Table 1
<commandDetails> This byte is RFU.
<text> String to display when TA in Idle Mode.
<iconQualifier> Unsigned Integer, range 0 – 255, used as a bitfield.
bit 1: 0 = icon is self explanatory and replaces text
1 = icon is not self-explanatory and shall be
displayed with the text
Determined value only if associated icon id is
not 0 (an icon exists).
bits 2-8: = RFU
<iconId> 0-255, 0: no icon
Reference
Siemens
Note
It is possible to issue AT^SSTGI during states IDLE, PAC and WAIT for this
Proactive Command without previously receiving an URC ^SSTN:<cmdType>,
see section “AT^SSTGI Remote-SAT Get Information – Generic Format”, pg.
22.
To Next Page
Loading...
Need help?
General
