Siemens MC35 Terminal User Manual

Remote-SAT User's Guide
P R E L I M I N A R Y
MC35_SAT_01_V01.01a - Preliminary Page 24 of 64 15.11.2001
1.4.3 AT^SSTGI Remote-SAT Get Information – Set Up Event List (5)
Write command
AT^SSTGI=5
This command is mainly to be used upon receiving an unsolicited result code
^SSTN:5. However, please refer to note below.
The response informs the TA of the events that it must monitor within itself. If
any of these events then occur the TA must report them to the ME.
Response
^SSTGI: <cmdType>, <commandDetails>, <eventList> <CR> <LF>
Parameters
<cmdType> 5 – Proactive command ID, see Table 1
<commandDetails> This byte is RFU.
<eventList> Unsigned integer, range 0-255, used as bitfield:
bit 1-4 RFU
bit 5 0 User Activity not in Event List
1 Any user activity (keyboard press) has to be signaled to the
ME.
bit 6 0 Idle Screen Available not in Event List
1 Any idle screen available event has to be signaled to the ME.
bit 7 RFU
bit 8 0 Language Selection not in Event List
1 Language Selection events have to be signaled to the ME.
The event list tells the TA which events have to be reported to the ME via the
related commands AT^SSTR=(232, 233, 235).
Reference
Siemens
Note
It is possible to issue AT^SSTGI during states IDLE, PAC and WAIT for this
Proactive Command without previously receiving an URC ^SSTN:<cmdType>,
see section “AT^SSTGI Remote-SAT Get Information – Generic Format”, pg.
22.

Siemens MC35 Terminal Specifications

General

Brand	Siemens
Model	MC35 Terminal
Category	Modem
Language	English