Siemens MC35 Terminal User Manual

Remote-SAT User's Guide
P R E L I M I N A R Y
MC35_SAT_01_V01.01a - Preliminary Page 27 of 64 15.11.2001
1.4.5 AT^SSTGI Remote-SAT Get Information – Send SS (17)
Write command
AT^SSTGI=17
This command is to be used upon receiving an unsolicited result code
^SSTN:17.
The module is sending a supplementary service request to the network, and is
alerting the user of this. Text and an Icon Identifier can be passed to the TA to
display to the user.
Text and an Icon Identifier can be passed to the TA to display to the user.
Response
^SSTGI: <cmdType>, [<commandDetails>], [<text>], <iconQualifier>, <iconId>,
<CR>, <LF>
Parameters
<cmdType> 17 – Proactive command ID, see Table 1
<commandDetails> This byte is RFU.
<text> String
<iconQualifier> Unsigned Integer, range 0 – 255, used as a bitfield.
bit 1: 0 = icon is self explanatory and replaces text
1 = icon is not self-explanatory and shall be
displayed with the text
Determined value only if associated icon id is
not 0 (an icon exists).
bits 2-8: = RFU
<iconId> 0-255, 0: no icon
Reference
Siemens
Note

Siemens MC35 Terminal Specifications

General

Brand	Siemens
Model	MC35 Terminal
Category	Modem
Language	English