Siemens MC35 Terminal User Manual

Remote-SAT User's Guide
P R E L I M I N A R Y
MC35_SAT_01_V01.01a - Preliminary Page 28 of 64 15.11.2001
1.4.6 AT^SSTGI Remote-SAT Get Information – Send USSD (18)
Write command
AT^SSTGI=18
This command is to be used upon receiving an unsolicited result code
^SSTN:18.
The module is sending an unstructured supplementary service request to the
network, and is alerting the user of this.
Text and an Icon Identifier can be passed to the TA to display to the user.
Response
^SSTGI: <cmdType>, [<commandDetails>], [<text>], <iconQualifier>, <iconId>
<CR> <LF>
Parameters
<cmdType> 18 – Proactive command ID, see Table 1
<commandDetails>This byte is RFU.
<text> String
<iconQualifier> Unsigned integer, range 0 – 255, used as a bit field.
bit 1: 0 = icon is self explanatory and replaces text
1 = icon is not self-explanatory and shall be
displayed with the text
Determined value only if associated icon id is
not 0 (an icon exists).
bits 2-8: = RFU
<iconId> 0-255, 0: no icon
Reference
Siemens
Note

Siemens MC35 Terminal Specifications

General

Brand	Siemens
Model	MC35 Terminal
Category	Modem
Language	English