Siemens MC35 Terminal User Manual

Remote-SAT User's Guide
P R E L I M I N A R Y
MC35_SAT_01_V01.01a - Preliminary Page 31 of 64 15.11.2001
1.4.9 AT^SSTGI Remote-SAT Get Information – Play Tone (32)
Write command
AT^SSTGI=32
This command is to be used upon receiving an unsolicited result code
^SSTN:32.
The Module has been instructed to make an audible tone, and may pass the TA
some information to support this.
Text and an Icon Identifier can be passed to the TA to display to the user.
Response
^SSTGI: <cmdType>, <commandDetails>, <infoText>, <iconQualifier>, <iconId>
<CR> <LF>
Parameters
<cmdType> 32 – Proactive command ID, see Table 1
<commandDetails> This byte is RFU.
<infoText> String to accompany tone
<iconQualifier> Unsigned Integer, range 0 – 255, used as a bitfield.
bit 1: 0 = icon is self explanatory and replaces text
1 = icon is not self-explanatory and shall be
displayed with the text
Determined value only if associated icon id is
not 0 (an icon exists).
bits 2-8: = RFU
<iconId> 0-255, 0: no icon
Reference
Siemens
Note
Command is issued if the SIM application requests playing a tone with a length
more than 5 seconds.

Siemens MC35 Terminal Specifications

General

Brand	Siemens
Model	MC35 Terminal
Category	Modem
Language	English