Siemens RDF800KN Series User Manual

6 / 94
Siemens RDF800KN.., RDF800KN/VB, RDD810KN/NF Basic documentation CE1P3174en
Smart Infrastructure 2020-02-21
1.4 Target audience, prerequisites
This document assumes that users of the
RDF800KN../RDF800KN/VB/RDD810KN.. thermostats are familiar with the ETS
and/or Synco ACS tools and can use them.
It is also assumed that these users are aware of the specific conditions associated
with KNX.
In most countries, specific KNX know-how is conveyed through training centers
certified by the KNX Association (see www.knx.org/).
For reference documentation, see section 1.2.
1.5 Conventions used in this document
Throughout this document, parameters are specified as P[parameter number].
For example, P30.
1.6 Glossary
The inputs, outputs and parameters of an application can be influenced in various
ways. These are identified by the following symbols in this document:
Parameters identified by this symbol are set using ETS.
Parameters identified by this symbol are set using ACS.
The setting of RDF800KN../RDF800KN/VB/RDD810KN.. parameters is only
supported by the following tool versions:
– ETS4 or higher
– ACS version 8.28 or higher
Inputs and outputs identified by this symbol communicate with other KNX devices.
They are called communication objects (CO).
The communication objects of the RDF800KN../RDF800KN/VB/RDD810KN.. room
thermostats work partly in S-mode, partly in LTE mode, and partly in both. These
objects are described accordingly.
A list of the parameters is shown in section 3.14.
ETS
ACS
STOP
Note!

Siemens RDF800KN Series Specifications

General

Brand	Siemens
Model	RDF800KN Series
Category	Thermostat
Language	English