Important Information
iv
ET 200S Interface Module IM 151/CPU
A5E00058783-01
Applicability
This manual is valid for the IM 151/CPU interface module with the order numbers
6ES7 151-7AA00-0AB0 and 6ES7 151-7AB00-0AB0 as well as the components of
the ET 200S specified in the
ET 200S Distributed I/O System
manual.
This manual contains a description of the components that were valid at the time
the manual was published. We reserve the right to enclose a Product Information
bulletin containing up-to-date information about new components and new versions
of components.
Standards, Certificates and Approvals
The ET 200S distributed I/O system is based on EN 50170, Volume 2, PROFIBUS.
The ET 200S distributed I/O system fulfills the requirements and criteria of
IEC 1131, Part 2 and the requirements for obtaining the CE marking. CSA, UL and
FM certifications have been obtained for the ET 200S.
Shipbuilding certification has been applied for.
You will find detailed information on these standards, certificates and approvals in
the
ET 200S Distributed I/O System
manual.
Position in the Information Landscape
In addition to the ET 200S manuals, you will also need the manual for the DP
master used and the documentation for the configuration and programming
software used (see the list in Appendix A of the
ET 200S Distributed I/O System
manual).
Note
You will find a detailed list of the contents of the ET 200S manuals in Section 1.2
of this manual.
We recommend that you begin by reading this section so as to find out which parts
of which manuals are most relevant to you in helping you to do what you want to
do.
To Next Page
Loading...
Need help?
General
