Device maintenance and repair
6.5 Recycling and disposal
IFP V2, IFP V2 PRO, IFP V2 ETH
Operating Instructions, 03/2023, A5E46641410-AE
83
6.4.2 Restoring the factory settings for an Ethernet Monitor
When the Ethernet Monitor was operated in the LAN network, it has an individual IP address.
When you connect the Ethernet Monitor to another location in the network, it is no longer
found because the Ethernet Monitor software is looking for the default IP address. When the
factory settings are restored, the IP address of the Ethernet Monitor is reset to the default
value "192.168.1.2".
You use the Reset button to restore the factory settings for the Ethernet Monitor.
Procedure
1. Switch off the device's power supply.
2. Press the reset button with a suitable tool and keep the reset button pressed.
3. Switch on the device's power supply and keep the reset button pressed for an additional
10 seconds.
During this the two LAN LEDs are deactivated briefly.
6.5 Recycling and disposal
The devices described in these operating instructions can be recycled thanks to their low level
of pollutants.
Contact a certified disposal service company for electronic scrap for environmentally sound
recycling and disposal of your old devices, and dispose of the device according to the relevant
regulations in your country.
To Next Page
Loading...
Need help?
General