Installing and connecting the device
3.3 Mounting the PRO device
IFP V2, IFP V2 PRO, IFP V2 ETH
Operating Instructions, 03/2023, A5E46641410-AE
47
3.3 Mounting the PRO device
3.3.1 Notes on mounting
The device must be mounted securely.
Insufficiently dimensioned mounting material may cause the device to fall down. Serious
physical injury may result.
Ensure that mounting material used is adequately dimensioned during installation. Make
sure to consider the weight of the device and the forces acting on the device when
dimensioning. This applies in particular to dynamic load of the device. All fasteners
including mounting surfaces, support arm systems, and mounting material such as screws
must be able to carry at least four times the weight of the device.
Observe any further statutory specifications applying at the location of use of the device and
further applicable regulations with regard to fastening the device.
Observe the torque specifications in the following sections.
Degree of protection for overall device
If you are using a support arm system or a pedestal system that does not have IP65 degree
of protection or Enclosure Type 4X/12 (indoor use only), IP65 degree of protection or
Enclosure Type 4X/12 (indoor use only) are lost for the entire device. Spray and water jets as
well as penetrating substances can then damage the device.
Use a suitable support arm system or pedestal system with IP65 degree of protection or
Enclosure Type 4X/12 (indoor use only) for your application.
To Next Page
Loading...
Need help?
General