Technical information
7.2 Electromagnetic compatibility
IFP V2, IFP V2 PRO, IFP V2 ETH
Operating Instructions, 03/2023, A5E46641410-AE
91
• DNV (Det Norske Veritas)
• LR (Lloyds Register)
• CCS (China Classification Society)
• NK (Nippon Kaiji Kyokai)
• KR (Korean Register of Shipping)
After acceptance has been granted, you can find the corresponding certificates on the
Internet at the following addresses:
• IFP certificates (https://support.industry.siemens.com/cs/ww/en/ps/16788/cert)
• IFP PRO certificates (https://support.industry.siemens.com/cs/ww/en/ps/21662/cert)
7.2 Electromagnetic compatibility
The device fulfills, among other things, the requirements of the EMC directive applicable to
the European domestic market.
Installing the device according to EMC directive
EMC-compliant mounting of the device and the use of interference-proof cables provide the
basis for interference-free operation.
Observed the following manuals in addition to these operating instructions:
• Designing interference-free controllers
(https://support.industry.siemens.com/cs/ww/en/view/59193566)
• Industrial Ethernet / PROFINET - Passive network components
(https://support.industry.siemens.com/cs/ww/en/view/84922825)
Pulse-shaped disturbance
The following table shows the electromagnetic compatibility of modules with regard to pulse-
shaped interference. The precondition for electromagnetic compatibility is that the device
meets the specifications and guidelines for electrical installation.
Pulse-shaped interference Tested with Performance
level equiva-
in accordance with
IEC 61000-4-2
Contact discharge: 6 kV (built-in device on the front,
PRO devices and Transceiver Unit all-round)
Contact discharge: 4 kV (built-in devices, at rear)
(high-speed transient inter-
ference)
in accordance with
2 kV power supply line
1 kV signal line, < 30 m
To Next Page
Loading...
Need help?
General