Parameters
4.2 Motor control
SIMOCODE pro - Parameterize
54 Operating Manual, 04/2017, A5E40507630002A/RS-AA/001
●
PC or PC/OPC UA [HMI] control station:
This control station is primarily intended for
switching commands on an arbitrary PC that, along with the automation system, is used
as a second master on PROFIBUS DP or that, as a client, accesses the data made
available by SIMOCODE pro, as server, via OPC UA. The control commands are sent via
the Acyclic receive telegram from PROFIBUS DPV1 or are transferred using a client-
server connection via OPC UA.
ES or SIMATIC PDM PC software is connected to SIMOCODE pro via
communication bus, its control commands automatically take effect via the PC
[DPV1] or
PC/OPC UA" control station. At the same time, the enabled commands for this
control station also take effect for SIMOCODE
ES.
To Next Page
Loading...
Need help?
General
