Siemens SIMOTICS S-1FT2 User Manual

6.2 Checklists prior to mounting
Procedure
Note
Required checks
The checklists below do not purport to be complete. It may be necessary to perform additional
checks and tests in accordance with the situation speci󹪝c to the particular installation site.
• Install the motor as described in the following chapters of the operating instructions.
• Thoroughly familiarize yourself with the safety instructions and observe the checklists below
before starting any work.
Table 6-1 Checklist prior to installation
Check OK
General checks
Are all necessary components of the con󹪝gured drive available? 
Are the ambient conditions in the permissible range?
• Section "Ambient conditions (Page28)"

Table 6-2 Checklist to check the mechanical system
Check OK
Is the motor free of visible damage? 
Have the mounting surfaces (e.g. 󹪞ange, shaft) on the customer machine and on the
motor been cleaned?

Are the mounting surfaces free of corrosion? 
Do the mounting dimensions (e.g. shaft diameter, shaft length, true run) on the customer
machine meet the speci󹪝cation?

Mounting
6.2Checklists prior to mounting
SIMOTICS S-1FT2 synchronous motors for SINAMICS S120
Operating Instructions, 12/2023, A5E50610821B AF 69

Siemens SIMOTICS S-1FT2 Specifications

General

Brand	Siemens
Model	SIMOTICS S-1FT2
Category	Engine
Language	English