Siemens SIPART DR24 User Manual

Manual
3 Operation
3.3 Configuring Mode (Parameterization and Configuring Mode)
SIP ART DR24 6DR2410
C79000-G7476-C153-03
135
3.3 Configuring Mode (Parameterization and Configuring Mode)
The instrument settings are made in the configuring mode.
Settings in the ”Parameterization mode” onPA and AdAP can be made in online.
The settings in the ”Configuring mode” (oFPA, ... to CAE5) are made offline. The dA2 shows a
striped pattern to identify the offline mode. The analog and digital outputs behave as described in
chapter 1.5.3, page 29. The behavior of the analog and digital outputs can be varied with the data
source nStr (no configuring) which is low during the individual structuring modes including the para-
meterization preselection mode.
The analog display dA1 and the LEDs L1, L3 to L8, L10 to L13 are dark and key tA5 has no
function.
The key tA1 becomes the Exit key, the corresponding LED L2 indicates standby to exit. When-
ever L2 flashes, pressing the Exit key causes a jump from the selected level to the next level up
in the hierarchy.
Key tA4 becomes the Enter key, the corresponding LED L9 indicates standby to enter. When-
ever L9 flashes, pressing the Enter key causes a jump to the next level down in the hierarchy
(pre--selection level --> configuring level, e.g. onPA)
The keys tA2 and tA3 serve to adjust the variables (mode name, answer or parameter value)
shown in the digital display dd1. The keys tA6/7 serve to adjust the variables (roLL--SEt, ques-
tion, function name and parameter name) shown in the digital displays dd2 and dd3.
The question and answer cycles, the parameter names and the parameter values with a large
number range can be adjusted with a fast action in the structuring modes oFPA, CLPA, hdEF,
FdEF, FCon, FPoS. To do this, first the adjustment direction is selected with tA2 or tA3 or tA6 or
tA7 and then the fast action switched on by pressing the other direction key. The operating
mode roLL or SEt is selected with tA6/7 in the configuring preselection level. Adjustment of the
parameter value or the answer cycle is only possible in the individual configuring modes in the
SEt operating mode. The adjusting keys tA2/3 are blocked in the roLL operating mode. This
enables offline parameters, function definitions or wirings to be viewed for example without hav-
ing to fear accidental adjustment of the entered data.
After exiting the paramterization mode, the data are saved in the non--volatile user program
memory and the SIPART DR24 switches to online mode. If changes have been made in the
configuring modes hdEF, FdEF, FCon, FPoS, the counting, timing and memory functions react
like for a Power--on reset with batt = no. The outputs are set to the values/states specified for
the individual functions.
It is possible to block the parameterization or configuring modes through the data sinks bLb
(Block operation), bLPS (Block parameterization/configuring) and bLS (Blocking configuring)
(see chapter 3.2, page 131 and figure 3-3, page 134).

Siemens SIPART DR24 Specifications

General

Brand	Siemens
Model	SIPART DR24
Category	Controller
Language	English