ALC700 Series Light Tower Set Controller
ALC700 Series Light Tower Set Controller 2018-03-02 Version 1.4 Page 23 of 51
5.8 MANUAL START/STOP
A. Press ，its indicator light on, and controller enters Manual Mode (Picture 1). Press
，light tower set begin cranking (Fig 2).
B. Press , the light relay will activate (if configured) while deactivate by pressing
again.
C. When warming up delay is over, in addition, generator voltage and frequency has reached
on-load requirements(Voltage≥on-load voltage and frequency≥on-load frequency), 1#～8#
lights will illuminate in proper order by pressing button while off in proper order by
pressing button. (Fig 3,4)
To Next Page
Loading...
Need help?
General
