SMC Networks JXC73 Series User Manual

- 100 -
No.SFOD-OMT0010-B
[Storage]
Warning
1. Do not store the product with direct contact to rain or water drops. Do not store the
product where it is exposed to harmful gases or liquid.
2. Store in an area that is shaded from direct sunlight and has a temperature and
humidity within the specified range (-10
o
C to 60
o
C and 35 to 85%. No condensation or
freezing.)
3. Do not apply vibration or impact to the product during storage.
13.5 Maintenance and Precautions
Warning
1. Do not disassemble or repair the product.
Fire or electric shock can result.
2. Before modifying or checking the wiring, the voltage should be checked with a tester 5
minutes after the power supply is turned off.
Electric shock can result.
Caution
1. Perform maintenance inspection according to the procedure indicated in the
Operation Manual.
Incorrect handling can cause an injury, damage or malfunction of equipment and machinery.
2. Removal of product
When equipment is serviced, first confirm that measures are in place to prevent dropping of
work pieces and run-away of equipment, etc, then cut the power supply to the system. When
machinery is restarted, check that operation is normal with actuators in the proper positions.
3. The actuator cable must be removed when manually operating the actuator.
If the sliding part is moved while the actuator and the controller are connected, the actuator
will not move smoothly because the induced voltage of the motor is applied to the controller.
Aninduced voltage may damage the controller when the actuator is used at high frequency.
[Lubrication]
Caution
1. The product has been lubricated for life at the manufacturer's and does not require
lubrication in service.
Contact SMC if lubrication is to be applied.
13.6 Precautions for actuator with lock
Warning
1. Do not use the lock as a safety lock or a control that requires a locking force.
The lock used for the product with a lock is designed to prevent dropping of work pieces.
2. When use the actuator except for horizontal mounting, must use the product with a
lock.
It becomes the cause of damaging the inside part of controller. If the product is not equipped
with a lock, the product will move and drop the work piece when the power is removed.
3. "Measures against drops” means preventing a work piece from dropping due to its
weight when the product operation is stopped and the power supply is turned off.

SMC Networks JXC73 Series Specifications

General

Brand	SMC Networks
Model	JXC73 Series
Category	Controller
Language	English