SMC Networks JXC73 Series User Manual

- 29 -
No.SFOD-OMT0010-B
The figure below shows how to mount the controller to the DIN rail. Hook part A on to the DIN
rail. Press part B on to the DIN rail and tighten the holding screws (M5 x 14). (Appropriate
tightening torque: 0.4 to 0.6Nm)
(2) Grounding
Fit the grounding cable with crimped terminal between the M3 screw and shakeproof washer as
shown below and tighten the screw.
Caution
The cable with crimped terminal and shakeproof washer must be prepared by the user.
The controller must be connected to Ground to reduce noise.
Part A
Part B
Holding screw
M5X14
M3 screw
Grounding cable (with crimped terminal)
Shakeproof washer

SMC Networks JXC73 Series Specifications

General

Brand	SMC Networks
Model	JXC73 Series
Category	Controller
Language	English