- 97 -
No.SFOD-OMT0010-B
Caution
1. Use the product for the maximum usable stroke.
The product will be damaged if it is used with a stroke exceeding the maximum stroke. Refer
to the specifications of the product.
2. When the product repeatedly cycles with partial strokes, operate it at a full stroke at
least once a day or every 1,000 strokes.
Otherwise, lubrication can be lost.
3. Do not use the product in applications where excessive external force or impact force
is applied.
The product can be damaged. Components, including the motor, are manufactured to precise
tolerances, so the slightest deformation may cause faulty operation or seizure.
4. Return to origin cannot be carried out during operating.
5. Refer to a common auto switch (Best Pneumatics No 2), when an auto switch is built
and used within the system.
13.2 Mounting
Warning
1. Read and understand the Operation Manual before installing and operating the product.
Keep the manual in a safe place for future reference.
2. Observe the tightening torque for screws.
Tighten screws to the recommended torque for mounting the product.
3. Do not make any alterations to this product.
Alterations made to this product may lead to a loss of durability and damage to the product, which
can lead to human injury and damage to other equipment and machinery.
4. When using an external guide, the guide axis should be parallel to the actuator axis.
There will be damage/excessive wear on the lead screw if the external guide is not parallel.
5. When an external guide is used, connect the moving parts of the actuator and the load in
such a way that there is no interference at any point within the stroke.
Do not scratch or dent the sliding parts of the actuator tube or piston rod etc., by striking them with
other objects. Components are manufactured to precise tolerances, so the slightest deformation
may cause faulty operation.
6. Prevent the seizure of rotating parts (pins, etc.) by applying lubricating grease.
7. Do not use the product before verifying that the equipment can operate properly.
After mounting or repair, connect the power supply to the product and perform appropriate
functional inspections to check it is mounted properly.
To Next Page
Loading...
Need help?
General
