68 Before Operating / Turning on the Power
B Operation Using the Supplied Remote Commander
Before Operating
Before operating the camera, check that the
camera and peripheral devices are properly
installed and connected.
For details, see “Setting of the SYSTEM
SELECT switch” (page 55), “Installing the
Camera” (page 74) and “Connections”
(page 75).
• The supplied remote commander may not
work correctly near the inverter lighting
fixtures. In such a case, try to install the
camera far from the inverted luminaire.
• You can check whether or not the installed
location is good for the usage of the
remote commander.
For detailed information on how to check,
refer to the Technical Manual. For details
on obtaining a Technical Manual, consult
your Sony dealer.
Turning on the
Power
1 Connect the camera to an AC outlet
using the supplied AC power adaptor
and power cord.
The power is turned on and the POWER
lamp lights.
The camera will automatically pan and
tilt and be reset to the position stored in
POSITION 1 (Pan/tilt reset action).
2 Turn on the peripheral devices.
To turn on/off the camera using the
remote commander
As long as the camera is connected to an AC
outlet, you can turn the camera on or off with
the POWER switch on the remote
commander.
When you turn the power off using the
remote commander, the POWER lamp turns
Notes
to AC outlet
POWER lights.
DC IN 12 V
To Next Page
Loading...
Need help?
General
Weight and Dimensions
