86 Specifications
Specifications
System
Video signal EVI-HD7V: 1920×1080p/59.94,
1920×1080p/50, 1920×1080p/
29.97, 1920×1080p/25,
1920×1080i/59.94,
1920×1080i/50, 1280×720p/
59.94, 1280×720p/50,
1280×720p/29.97, 1280×720p/
25, 640×480p/59.94 (LB),
VISCA CONTROL (switched
with the SYSTEM SELECT
switch)
EVI-HD3V: 1280×720p/59.94,
1280×720p/50, 1280×720p/
29.97, 1280×720p/25,
640×480p/59.94 (LB), VISCA
CONTROL (switched with the
SYSTEM SELECT switch)
Synchronization
Internal synchronization
Image device 1/3 type (6 mm), CMOS
Lens 10× (optical), 40× (digital)
f = 3.4 – 33.9 mm, F1.8 – F2.1
Horizontal angle: 8 (TELE end) to
70 degrees (WIDE end)
Minimum object distance
100 mm (4 inches) (WIDE end)
Minimum illumination
15 lux (F1.8) with 50 IRE
Shutter speed 1/50, 1/60 to 1/10,000 sec.
Video S/N 50 dB
Pan/tilt action Horizontal: ±100 degrees
Maximum panning speed:
300 degrees/sec.
Vertical: ±25 degrees
Maximum tilting speed:
125 degrees/sec.
Input/output connectors
Video output
COMPONENT (VIDEO OUT):
DVI-I connector
Y: 1 Vp-p (sync, at 75-ohm
termination)
Pb/Pr: ±350 mVp-p, 75-ohm
terminated
HD/VD Sync: 3.3 Vp-p
DVI Digital VIDEO (VIDEO
OUT): DVI-I connector
Control input/output
VISCA IN: Mini DIN 8-pin type,
RS-232C
VISCA OUT: Mini DIN 8-pin
type, RS-232C
Power connector
JEITA type4 (DC IN 12 V)
General
Input voltage 12 V DC (10.8 to 13.0 V DC)
Current consumption
2.2 A max. (at 12 V DC)
Operating temperature
0 ºC to 40 ºC (32 ºF to 104 ºF)
Storage temperature
–20ºC to +60ºC (–4ºF to 140ºF)
Dimensions Video camera: 250 × 152 ×
135 mm (9 7/8 × 6 ×
5 3/8 inches) (w/h/d)
Remote Commander: 56 × 26 ×
210 mm (2 1/4 × 1 1/16 ×
8 3/8 inches) (w/h/d)
Mass Video camera: Approx. 1.5 kg
(3 lb 5 oz)
Remote Commander: 109 g
(3.8 oz)
Installation angle
Less than ±15 degrees to the
horizontal surface
Supplied accessories
AC power adaptor (1)
AC power cord (1)
Remote Commander (1)
Operating Instructions (1)
Design and specifications are subject to
change without notice.
Note
Always verify that the unit is operating
properly before use. SONY WILL NOT
BE LIABLE FOR DAMAGES OF ANY
KIND INCLUDING, BUT NOT
LIMITED TO, COMPENSATION OR
REIMBURSEMENT ON ACCOUNT
OF THE LOSS OF PRESENT OR
PROSPECTIVE PROFITS DUE TO
FAILURE OF THIS UNIT, EITHER
DURING THE WARRANTY PERIOD
OR AFTER EXPIRATION OF THE
WARRANTY, OR FOR ANY OTHER
REASON WHATSOEVER.
To Next Page
Loading...
