70 Pan/Tilt and Zoom Operation
If the camera moves in a different
direction from the one you intended
The camera is preset so that the image output
from the camera is rotated toward the right
whenever you press the b button.
To face the camera toward the
opposite direction:
You might wish to face the camera toward
the opposite direction from that of the button
you pressed, for example, when you change
the direction of the camera while checking
the picture on the screen. In such a case,
press the 2 (REV) button while holding
down the L/R DIRECTION SET button.
To reset the setting
To reset the setting, press the 1 (STD) button
while holding down the L/R DIRECTION
SET button.
The setting above only changes the signal
emitted from the remote commander, and
does not change the setting of the camera
itself. Therefore, repeat the setting for each
remote commander if you are using more
than one remote commander.
If the STANDBY lamp of the camera
flashes
When the camera is moved or turned by
hand or by external shock, the
microcomputer inside the camera may not
be able to memorize the pan/tilt position
properly and the camera may stop.
To reset the pan/tilt position, press the PAN-
TILT RESET button or turn the power of the
camera off and, then turn it on again.
Press either of the ZOOM buttons.
When you perform pan/tilt operation while
the camera is in the telephoto mode, the
moving speed of the image on the screen
may be a little jerky.
Arrow
button
Movement of
the camera
Setting
Arrow
button
Movement of
the camera
Setting
Note
While
holding down
Press
While
holding down
Press
Zooming
Note
STANDBY flashes
Subject appears
farther away.
(Wide angle)
Subject appears
closer. (Telephoto)
Zooms in or out
fast (FAST side)
Zooms in or out
slowly (SLOW side)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
