6
2 Safety Instruction
This chapter mainly introduces safety instructions that need to be respected during
the operation of Logger1000.
The Logger1000 has been designed and tested strictly according to international
safety regulations. As electrical and electronic equipment, the Logger1000 must be
installed, commissioned, operated, and maintained in strict accordance with related
safety instructions. Incorrect operation or misuse of the device may cause:
damage to personnel safety of the operators or the third party
damage to the Logger1000 or other properties belong to the operators or the
third party
Therefore, the following safety instructions must be read and always kept in mind
prior to any work. All detailed work-related safety warnings and notes will be
specified at the critical points in corresponding chapter.
All operation and electrical work must only be performed by qualified
personnel.
Before Installation
After receiving the device, please check if there is damage caused during
transport. Contact SUMGROW
or the forwarding company once any
problem is detected.
The related operators must be familiar with the safety instructions in this
manual and other safety regulations about the installation, operation and
maintenance of the Logger1000.
Move, transport, install, operate, and maintain the Logger1000 correctly
and appropriately.
To Next Page
Loading...
Need help?
General
