Sungrow Logger1000 - Remote Maintenance; Message Export

User Manual 8 Web Interface
47
This operation will clear all data of the system.
8.11.3 Remote Maintenance
Click "System" -> "Remote maintenance" to enter the corresponding interface.
Tab. 8-1 Parameter description
Remote maintenance switch state
Description
Disabled
Not allow for remote maintenance on the
Logger1000
Enable
Allow for remote maintenance on the
Logger1000
In case the remote maintenance switch is in the "Enable" state, the remote service
address needs to be set. Users in mainland China select "iSolarCloud of China", users
in Europe select "iSolarCloud of Europe", and users in other regions select the
"iSolarCloud of International".
8.11.4 Message Export
Click "System" -> "Message export" to enter the corresponding interface.
Tab. 8-2 Parameter description
Parameter
Description
Range
Port -
Serial port: COM1, COM2, COM3
Network port: ETH, WiFi
Duration
Export the message recorded
during the set time
1min ~ 10min
Set parameters, including interface, serial port, and duration, and click "Start" to
start recording message. The recording automatically stops when the set time
reaches, or the user may manually click the button "Stop" to stop recoding message.