PERIODIC MAINTENANCE 2-11
ENGINE OIL AND OIL FILTER
Replace initially at five hours of operation and every
60 hours thereafter.
The oil should be changed while the engine is warm. Oil filter
replacement at the above intervals, should be done together with
the engine oil change.
ENGINE OIL REPLACEMENT
Place an oil pan below the engine, and then drain the oil by
removing the engine oil drain plugs (1, 2) and engine oil
filler cap 3.
Tighten the engine oil drain plugs (1, 2) to the specified
torque, and then pour the new oil through the oil filler hole.
When performing an oil change (without oil filter replacement),
the engine will hold about 1.7 L (1.8 US qt, 1.5 Imp qt) of oil.
Use an engine oil that meets API service classifications SF or
SG and that has a viscosity rating of SAE 10W-40.
Engine oil drain plug
(on the crankcase) 1: 21 N·m (2.1 kgf-m, 15.0 lb-ft)
(on the frame) 2:18 N·m (1.8 kgf-m, 13.0 lb-ft)
When installing the engine oil drain plug 2 with gas-
ket, face the taper of gasket to drain plug as shown.
Make sure that the engine is cooled.
Place the motorcycle on level ground and hold it vertically.
Install the oil filler cap 3.
Start the engine and allow it to run for three minutes at idling
speed.
Turn off the engine and wait about three minutes, and then
check the oil level on the dipstick 4. The oil level should be
between the “L” (low) and “F” (full) level lines. If the oil level is
lower than the “L” level line, add oil to the “F” level line.
NOTE:
Engine oil expands and oil level increase when the engine oil is
hot.
2
To Next Page
Loading...
Need help?
General
