Suzuki drz 400E Service Manual

3-42 ENGINE
BEARINGS
Wash the bearing with a cleaning solvent and lubricate it with
motor oil before inspection. Rotate the inner race and check to
see that it turns smoothly. If it does not turn quietly and smoothly,
or if there are signs of any abnormalities, the bearing is defec-
tive and must be replaced with a new one as follows.
RIGHT COUNTERSHAFT BEARING
Remove the bearing retainer.
Remove the right countershaft bearing using the special tool.
09921-20220: Bearing remover set
Replace the removed bearing with a new one.
Install the right countershaft bearings using the special tool.
09913-70210: Bearing installer set
Apply a small quantity of THREAD LOCK “1342” or THREAD
LOCK SUPER “1322” to the bearing retainer screws, and
tighten them securely.
For USA
99000-32050: THREAD LOCK “1342”
For the other countries
99000-32110: THREAD LOCK SUPER “1322”
LEFT COUNTERSHAFT BEARING
Remove the left countershaft bearing using the special tool.
09923-73210: Bearing remover
09930-30102: Sliding hammer
Replace the removed bearing with a new one.
Install the left countershaft bearing using the special tool.
09913-70210: Bearing installer set

Suzuki drz 400E Specifications

General

Brand	Suzuki
Model	drz 400E
Category	Motorcycle
Language	English