Suzuki drz 400E Service Manual

3-46 ENGINE
Install the driveshaft oil seal into the left crankcase slowly,
using the special tool.
09913-70210: Bearing installer set
GEARSHIFT SHAFT OIL SEAL
Remove the gearshift shaft oil seal from the left crankcase,
slowly using the special tool.
09913-50121: Oil seal remover
Replace the removed oil seal with a new one.
Install the gearshift shaft oil seal into the left crankcase slowly,
using the special tool.
09913-70210: Bearing installer set
OIL CHECK VALVE
Remove the bushing 1, oil check valve ball 2 and spring 3
from the right crankcase cover.
Install the spring 3, oil check valve ball 2 and bushing 1 to
the right crankcase cover 4 as shown.
The rubber part of bushing
11
11
1 must face to the out-
side.

Suzuki drz 400E Specifications

General

Displacement	398 cc
Compression Ratio	12.2:1
Ignition	Electronic ignition (CDI)
Transmission	5-speed constant mesh
Rear Suspension	Link type, coil spring, oil damped
Front Tire	80/100-21
Rear Tire	110/100-18
Engine Type	4-stroke, DOHC
Bore x Stroke	90.0 mm x 62.6 mm
Fuel System	Mikuni BSR36 carburetor
Front Brakes	Disc
Rear Brakes	Disc
Fuel Tank Capacity	10.0 L (2.6 US gallons)
Overall Width	825mm (32.5 inches)
Ground Clearance	315 mm (12.4 in)
Seat Height	935 mm (36.8 in.)
Curb Weight	138 kg (304 lbs)
Dry Weight	119 kg (262 lbs.)