2-38
CONTROLS
SWITCHES
DPD MANUAL REGENERATION /INHIBIT
SELECT SWITCH
• The DPD and the exhaust gas emitted
from the exhaust line can be very hot
while the engine is running or the
regeneration is under way, as well as
immediately after the engine is stopped.
Be careful not to accidentally touch
them; doing so could cause burns.
• Do not perform the DPD regeneration if
the machine is surrounded by
flammable items such as plants, trees,
dry grass, wastepaper, oil and waste
tires. There is a risk of fire due to the
high-temperature exhaust gas emitted
from the DPD.
• Do not perform the DPD regeneration in
poorly-ventilated indoor spaces, as
smoke may be generated during the
regeneration.
• Do not perform regeneration when the
engine hood is open. There is a risk of
fire due to the high-temperature exhaust
gas emitted from the DPD.
IMPORTANT: Press the manual
regeneration side on the DPD manual
regeneration/inhibit select switch to burn
the particulate matter (PM), when the
DPD manual regeneration lamp flashes
and an alarm sounds. If the machine
continues to be operated without
performing the manual regeneration, the
engine power will decrease and
eventually the engine will stop running.
The ECM warning display will also flash if
the DPD needs to be repaired. A number
appears on the engine error code screen.
Refer to the “Engine error code list” and
contact a Takeuchi sales or service dealer
for repair.
• DPD manual regeneration
When the DPD manual regeneration
symbol on the display starts flashing and
an alarm starts sounding, perform the DPD
manual regeneration by following the
procedure below.
1.Park the machine in a safe place where
there is no fire hazard.
2.Raise the safety lock lever to the lock
position.
· Do not lower the safety lock lever and
move the control levers during
regeneration. Doing so interrupts the
regeneration.
3.Decrease the engine speed to low idling.
4.Press and hold the manual regeneration
side on the DPD manual regeneration/
inhibit select switch.