EasyManua.ls Logo

TOHATSU MX 50D2 User Manual

TOHATSU MX 50D2
178 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #52 background imageLoading...
Page #52 background image
INSPECTION AND MAINTENANCE52
9
When morning in cold weather at sub-zero
temperatures the water in the cooling
water pump may freeze and severely dam-
age the pump, impeller, and associated
parts. To avoid this, submerge the lower
half of the engine into the water, or tilt the
engine up above water level and the recoil
starter several times to drain the water
completely.
7. Precautions in cold weather
MWX50D2_E.book Page 52 Thursday, August 18, 2011 5:29 PM

Table of Contents

Other manuals for TOHATSU MX 50D2

Question and Answer IconNeed help?

Do you have a question about the TOHATSU MX 50D2 and is the answer not in the manual?

TOHATSU MX 50D2 Specifications

General IconGeneral
Engine Type2-Stroke
StartingManual
Gear Ratio2.08:1
Fuel TypeGasoline
Oil Type2-stroke engine oil
Shaft Length15 inches

Summary

General Safety Information

Safety Warnings and Symbols

Explains DANGER, WARNING, CAUTION, and Note indicators for critical information.

Emergency Stop Switch and Safe Operation

Details the emergency stop switch function and general safe boat operation practices.

Servicing, Maintenance, and Mounting

Outlines recommendations for authorized service, owner maintenance duties, and proper motor mounting.

Specifications

Names of Parts

Installation

Mounting the Outboard Motor on Boat

Instructions for positioning and securing the outboard motor to the boat transom.

Propeller Selection Guide

Guidance on choosing a propeller for optimal engine performance at wide open throttle.

Pre-Operating Preparations

Recommended Gasoline Types

Specifies the type of unleaded gasoline required for optimal engine performance and longevity.

Recommended Engine Oil

Details the type of two-stroke engine oil and fuel-to-oil mixing ratios for operation and break-in.

Break-in Procedure

Outlines the necessary steps for breaking in a new outboard motor for proper component seating and longevity.

Engine Operation

Starting and Warming Up

Procedures for safely starting the engine and warming it up to operating temperature.

Operating Modes and Conditions

Covers forward/reverse engagement, shallow water running, and mooring procedures.

Engine Stopping and Trim Adjustment

Proper engine stopping methods and how to adjust the trim angle for optimal boat handling.

Removing and Carrying the Outboard Motor

Removing the Outboard Motor

Steps required to safely detach the outboard motor from the boat for transport or storage.

Carrying and Storing the Outboard Motor

Guidelines for safely transporting and storing the outboard motor, including preparation steps.

Trailering

Adjustment

Trim Tab Adjustment

How to adjust the trim tab to balance steering loads for straight running.

Steering Load Adjustment

Adjusting the steering resistance for comfortable and safe operation.

Throttle Grip Turning Load Adjustment

Adjusting the friction on the throttle grip for smooth control and preventing accidental movement.

Inspection and Maintenance

Daily Inspection and Checks

Daily checks to perform before and after using the outboard motor for safety and performance.

Basic Maintenance Procedures

Covers washing the motor, and replacing propellers and spark plugs.

Scheduled and Seasonal Maintenance

Outlines periodic servicing, anode inspection, gear oil change, cleaning, storage, and pre-season checks.

Incident Response and Precautions

Procedures for checks after impact, engine submersion, and precautions for cold weather operation.

Troubleshooting

Tool Kit and Spare Parts

Optional Accessories

Propeller Table

Wiring Diagram

Related product manuals