CG-SVX17D-EN 47
Installation - Mechanical
Unit Isolation and Leveling
Mounting
Construct an isolated concrete pad for the unit or provide concrete footings at each of the four unit
mounting points. Mount the unit directly to the concrete pads or footings.
Level the unit using the base rail as a reference. The unit must be level within 1/4” over the entire
length. Use shims as necessary to level the unit.
Elastomeric Isolator Installation (optional)
Install the optional neoprene isolators at each mounting location. Isolators are identified by part
number and color.
1. Secure the isolators to the mounting surface, using the mounting slots in the isolator base plate,
as shown in Figure 40. Do not fully tighten the isolator mounting bolts at this time.
2. Align the mounting holes in the base of the unit, with the threaded
positioning pins on the top of the isolators.
3. Lower the unit on to the isolators and secure the isolator to the unit with a nut. Maximum
isolator deflection should be approximately 1/4”.
4. Level the unit carefully. Refer to “Leveling”. Fully tighten the isolator mounting bolts.
Figure 40. CGAM Elastomeric Isolator
«B»Dia
RP/RDP
«M»
H
H
A
E
L
C
W
DDia2Holes
B NC TAP
H
H
E
A
D
W
C
L
EXT
Max.
Load
each
(Lbs)
Defle c t ion
in
Inc hes
Fig A B C D E H L M W Type Color
57 250 BLACK
58 525 RED
59 750 GREEN
60 1100 GRAY
61 1500 BROWN
62 2250 RED
63 3000 GREEN
64 4000 GRAY
1.13
0.50 2 2.50 0.50 4.12 0.56 0.25 2.88 5.50 3.38 RDP3-WR
0.50 2 3.00 0.50 5.00 0.56 0.38 2.75 6.25 4.63 RDP4-WR-1.60+/-.25
To Next Page
Loading...
Need help?
General