36 Wireless Zone Sensor • BAS-SVX04A-EN
Operation, Maintenance, and Troubleshooting
Battery Life
Battery life is five years under normal conditions. If the battery is not used for an
extended period of time, either remove the batteries or set the sensor address to
000 and press the Test button (S5). This will place the sensor into a low-power
hibernation mode.
Note: If lithium batteries are temporarily unavailable, alkaline batteries can be
used. However, alkaline battery life is very short by comparison.
Battery Installation
WARNING
Prevent Injury!
Batteries can explode or leak and cause burns if installed backwards,
disassembled, charged, or exposed to water, fire, or high temperature.
WARNING
Prevent Injury!
Keep away from small children. If swallowed, promptly see doctor. Have doctor
telephone your poison control center.
Install two AA lithium batteries in the battery-holding slot that is molded into the
sensor cover. Observe the “+” and “–” polarity indicators that are molded into
the cover.
The sensor has been designed to prevent damage if the batteries are installed
backwards, thereby reducing the potential for injury.
To Next Page
Loading...
Need help?
General
