44 Wireless Zone Sensor • BAS-SVX04A-EN
Operation, Maintenance, and Troubleshooting
Returning a Sensor to its Factory Defaults
1. To return a sensor to its factory defaults, set the device address to 000. (For
more information about setting the address to 000, see “Setting the Sensor
Address,” p. 16.)
1. Press the Test button (S5) on the sensor to force the sensor to read the
address switches.
2. Confirm LED operation (see Ta b l e 5, p. 33).
Returning a Receiver to its Factory Defaults
1. To return a receiver to its factory defaults, set the device address to 000. (For
more information about setting the address to 000, see “Setting the Receiver
Address,” p. 16.)
The sensor reads the address as the switches are set.
2. Confirm LED operation (see Ta b l e 6, p. 33).
Replacing a Defective Sensor or Receiver
If either the sensor or receiver need to be replaced, follow this procedure:
1. Return the device that is still operational (either the sensor or the receiver) to
its factory defaults (see “Returning a Receiver to its Factory Defaults”).
2. Replace the malfunctioning or missing device by following the installation
procedures given in
“Setting the Address, Mounting, Wiring, and Associating
the Receiver and Sensor,” p. 13.
3. Associate the two devices to one another following the association
procedures given in either “
“Automatic Association,” p. 28” or “Manual
Association,” p. 28).
Forcing a Sensor to Transmit
It may be desirable to force a wireless zone sensor to transmit, for example,
during servicing an HVAC unit that is fitted with a wireless zone sensor system.
1. To force a transmission, press Test button (S5) on the sensor.
To Next Page
Loading...
Need help?
General
