Triumph Speed Twin 2019 User Manual

Cleaning and Storage
156
• If exposure to salt is unavoidable,
clean your leather product
immediately after each exposure
using a damp cloth then leave the
product to dry naturally at room
temperature.
• Gently clean any minor marks
with a damp cloth then leave the
product to dry naturally at room
temperature.
• Place your leather product in a
fabric bag or cardboard box to
protect it when in storage. Do not
use a plastic bag.
Storage
Preparation for Storage
To prepare the motorcycle for storage,
do the following:
• Clean and dry the entire vehicle
thoroughly.
• Fill the fuel tank with the correct
grade of unleaded fuel and add a
suitable fuel stabilizer (if available),
following the fuel stabilizer
manufacturer’s instructions.
Warning
Gasoline is extremely flammable
and can be explosive under certain
conditions.
Turn the ignition switch OFF. Do not
smoke.
Make sure the area is well ventilated
and free from any source of flame or
sparks; this includes any appliance
with a pilot light.
• Remove one of the spark plugs from
each cylinder and put several drops
0.17 fl oz (5 ml) of engine oil into each
cylinder. Cover the spark plug holes
with a piece of cloth or rag. With
the engine stop switch in the RUN
position, push the starter button for
a few seconds to coat the cylinder
walls with oil. Install the spark plugs,
tightening to 9 lbf ft (12 Nm).
• Change the engine oil and filter (see
page 104).
• Check and if necessary correct the
tire pressures (see page 133).

Triumph Speed Twin 2019 Specifications

General

Displacement	1200 cc
Compression Ratio	11.0:1
Fuel System	Multipoint sequential electronic fuel injection
Clutch	Wet, multi-plate assist clutch
Gearbox	6-speed
Frame	Tubular steel cradle
Front Tire	120/70 ZR17
Rear Tire	160/60 ZR17
Seat Height	807 mm
Dry Weight	196 kg
Wet Weight	216 kg
Fuel Tank Capacity	14.5 liters
Engine Type	Liquid-cooled, 8-valve, SOHC, 270° crank angle parallel twin
Bore x Stroke	97.6 mm x 80 mm
Max Torque	112 Nm @ 4, 950 rpm
Exhaust	Stainless steel 2 into 2 exhaust system with twin silencers
Final Drive	Chain
Front Suspension	120mm travel
Rear Suspension	Twin shocks, adjustable preload, 120mm rear wheel travel
Front Brakes	ABS
Rear Brakes	Single 220mm disc, Nissin 2-piston floating caliper, ABS
Front Wheel	Cast aluminium
Rear Wheel	Cast aluminum
Wheelbase	1, 410mm
Max Power	97 PS / 96 bhp (71.5 kW) @ 6, 750 rpm