General Information
37
Caution
Stop the engine immediately if the
high coolant temperature warning
light illuminates. Do not restart
the engine until the fault has been
rectified.
Severe engine damage will result from
running the engine when the high
coolant temperature warning light is
illuminated.
Immobiliser/Alarm Indicator Light
This Triumph motorcycle is
equipped with an engine
immobilizer which is activated
when the ignition switch is
turned to the OFF position.
Without Alarm Equipped
When the ignition switch is turned to
the OFF position, the immobilizer/alarm
light will flash on and off for 24 hours to
show that the engine immobilizer is on.
When the ignition switch is turned to
the ON position the immobilizer and the
indicator light will be off.
If the indicator light remains on it
indicates that the immobilizer has a
malfunction that requires investigation.
Contact an authorized Triumph dealer
as soon as possible to have the fault
checked and rectified.
With Alarm Equipped
The immobilizer/alarm light will
only illuminate when the conditions
described in the genuine Triumph
accessory alarm instructions are met.
Anti-lock Braking System (ABS)
Warning Light
When the ignition switch is
turned to the ON position, it is
normal that the ABS warning
light will flash on and off. The
light will continue to flash after engine
start-up until the motorcycle first
reaches a speed exceeding 6 mph
(10 km/h) when it will go off.
Note
Traction control will not function if
there is a malfunction with the ABS.
The warning lights for the ABS, traction
control and the MIL will be illuminated.
The warning light will not illuminate
again until the engine is restarted
unless there is a fault, or the ABS is
disabled by the rider.
If the ABS is disabled by the rider the
warning light will illuminate until the
ABS is enabled again.
If there is a fault with the ABS system
the warning light will be illuminated and
the general warning symbol will flash.
Warning
If the ABS is not functioning, the brake
system will continue to function as a
non-ABS braking system.
Do not continue to ride for longer than
is necessary with the indicator light
illuminated.
Contact an authorized Triumph dealer
as soon as possible to have the fault
checked and rectified. In this situation
braking too hard will cause the wheels
to lock resulting in loss of motorcycle
control and an accident.
To Next Page
Loading...
Need help?
General
