40
General Information
Seat
1. S e a t
2. Fixing
3. Stepped sleeve
The seat can be removed to gain access to
the battery, owner's handbook etc. An Allen
key, located beneath the right hand side
panel on Bonneville, Bonneville SE,
Bonneville T100 and Thruxton models, and
beneath the left hand side panel on
Scrambler, is provided to allow removal of
the seat fasteners.
To locate the Allen key, remove the right
hand side cover (left hand side cover on
Scrambler) as described earlier in this section.
On all models except Scrambler, the
Allen key is located in a retainer, beneath the
fuse box. On Scrambler models, the Allen
key is located in a retainer between the two
rearmost relays.
Remove the fixings from the rear of the seat,
collecting the stepped sleeves, and lift the
seat clear of the frame.
Seat Care
To prevent damage to the seat or seat cover,
care must be taken not to drop or lean the
seat against any surface which may damage
the seat or seat cover.
To refit, locate the seat to the frame ensuring
the locating tongue is correctly positioned
beneath the fuel tank bridge.
Finally, refit the stepped sleeves, and tighten
the seat retaining screws.
Store the Allen key in the space provided and
refit the right/left hand side cover.
To prevent damage to the seat or seat
cover, care must be taken not to drop the
seat. Do not lean the seat against the
motorcycle or any surface which may
damage the seat or seat cover. Instead,
place the seat, with the seat cover facing
upwards, on a clean, flat surface which is
covered with a soft cloth.
Do not place any item on the seat which
may cause damage or staining to the seat
cover.
To Next Page
Loading...
Need help?
General
