EasyManuals Logo

Triumph Thruxton Handbook

Triumph Thruxton
124 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #46 background imageLoading...
Page #46 background image
46
How to Ride the Motorcycle
1. Engine stop switch
2. Starter button
3. Neutral indicator light
4. Choke
5. Ignition switch
To Stop the Engine
Close the throttle completely.
Select neutral.
Turn the ignition switch off.
Select first gear.
Support the motorcycle on a firm
and level surface with the side stand.
Withdraw the ignition key from the
ignition switch.
Engage the steering lock (see
page 32).
To Start the Engine
Release the steering lock.
Check that the engine stop switch is
in the RUN position.
Insert the ignition key and turn the
ignition switch to the ON position.
Ensure that the transmission is in
neutral.
Pull the clutch lever fully into the
handlebar.
If the engine is cold, pull out the
choke, noting the following: Above
25°C air temperature, pull out the
choke to the first position. Below
25°C air temperature, pull out the
choke fully.
If the engine is partly warm, pull out
the choke to the first position.
Leaving the throttle completely
closed, push the starter button until
the engine starts.
Release the clutch lever slowly.
During warm-up, gradually push the
choke in a little at a time as
necessary to prevent the engine
from racing or stalling.
1
2
3
4
5
ccjh
Caution
The engine should normally be stopped by
turning the ignition switch to the OFF
position. The engine stop switch is for
emergency use only. Do not leave the
ignition switched on with the engine
stopped. Electrical damage may result.

Table of Contents

Other manuals for Triumph Thruxton

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Triumph Thruxton and is the answer not in the manual?

Triumph Thruxton Specifications

General IconGeneral
Displacement1200 cc
Transmission6-speed
Bore x Stroke97.6 mm x 80 mm
Max Torque112 Nm @ 4, 950 rpm
Fuel SystemFuel injection
Final DriveChain
ClutchWet, multi-plate
FrameTubular steel
Rear SuspensionTwin shocks
Front BrakesDual 310mm discs, 2-piston calipers
Rear BrakesSingle 220mm disc, 2-piston caliper
Front Wheel17 x 3.5 in
Rear Wheel17-inch
Length2100 mm (82.7 in)
Width (Handlebars)745 mm (29.3 in)
Height1, 030mm
Seat Height810mm
Wheelbase1, 415mm
Rake22.8 º
Fuel Capacity14.5 liters
Weight (Dry)203kg
Weight (Wet)223kg
Exhaust2-into-2

Related product manuals