TSC M23 Programming Manual

TSC AUTO ID Technology Co., Ltd. 200 Copyright 2013 All Rights Reserved.
 GETSETTING$()
Description
This command is used to get printer settings.
Syntax
GETSETTING(app$,sec$,key$[,default$])
Parameter
Description
default$
Optional. Expression containing the value to return if no value is set in
the key$ setting. If omitted, default is assumed to be a zero-length string
("").
Note: This command has been supported since V6.72 EZ and later firmware.
app$
sec$
key$
Comment
SYSTEM
INFORMATION
DPI
Return printer resolution
MODEL
Return printer model name
SERIAL
Return Printer serial number
VERSION
Return Printer firmware version
CHECKSUM
Return Printer firmware checksum
RECORD
MILAGE
Return printed mileage
CUT COUNTER
Return cutter cuts
FILE
DRAM
CAPACITY
Return the total capacity of DRAM
AVAILABLE
Return the available capacity of DRAM
FLASH
CAPACITY
Return the total capacity of FLASH
AVAILABLE
Return the available capacity of FLASH
CARD
CAPACITY
Return the total capacity of CARD
AVAILABLE
Return the available capacity of CARD
INSTALLED
Return the status of card. 1: installed; 0: none installed.
CONFIG
NET
MAC ADDRESS
Return MAC address
IP ADDRESS
Return IP address
SUBNET MASK
Return Subnet Mask
DEFAULT GATEWAY
Return default gateway
COM1
BAUD RATE
Return baud rate of COM port
DATA BIT
Return data bit of COM port
PARITY
Return parity of COM port
STOP BIT
Return stop bit of COM port
SENSOR
SENSOR TYPE
Return the current sensor type
CARRIAGE
Return the status of head open sensor.
GAP INTENSION
Return intension of gap sensor.
BLINE INTENSION
Return intension of black mark sensor.
CONTINUOUS INTENSION
Return intension of continuous sensor.
TSPL
PRINT MODE
Return pos-print action.
DENSITY
Return print density
PAPER SIZE
Return paper size
GAP SIZE
Return gap size
BLINE SIZE
Return black mark size
DIRECTION
Return printing direction
MIRROR
Return mirror status.
RIBBON
Return ribbon status.
REPRINT
Return reprint status.
PAPER WIDTH
Return paper width
LIMIT FEED
Return maximum length for sensor calibration.
OFFSET
Return OFFSET value.
REFERENCE X
Return REFERENCE X value.
REFERENCE Y
Return REFERENCE Y value.
SHIFT X
Return SHIFT X value.
SHIFT Y
Return SHIFT Y value.
SPEED
Return print speed.
COUNTRY CODE
Return COUNTRY code.
CODEPAGE
Return CODEPAGE.

TSC M23 Specifications

General

Brand	TSC
Model	M23
Category	Printer
Language	English