To Next Page

To Previous Page

 SET AUTORUN

Description

This command redefines the BAS file which can be run automatically while switching on the printer.

Default is AUTO.BAS.

Syntax

SET AUTORUN "filename"

Parameter

Description

filename

The file will be defined to AUTO-RUN file. Default is AUTO.BAS.

Note:

 This command has been supported since V6.86 EZ and later firmware.

Example

Sample Code

REM *****Step1: Send the following command to redefine the auto-run file from "AUTO.BAS" to

"TEST.BAS"

SET AUTORUN "TEST.BAS"

REM *****Step2: Send the following commands to download "TEST.BAS" file into printer.

DOWNLOAD F,"TEST.BAS"

SIZE 4,1

GAP 0,0

DIRECTION 1

CLS

BLOCK 10,10,600,200,"3",0,1,1,12,"\["]TEST.BAS\["] is running automatically while turning on the

printer."

PRINT 1

EOP

REM *****Step3: Turn off and on the printer to run "TEST.BAS" automatically.

Result

TSC M23 Programming Manual

Other manuals for TSC M23