To Next Page

To Previous Page

 LIMITFEED

Description

If the gap sensor is not set to a suitable sensitivity while feeding labels, the printer will not be able to

locate the correct position of the gap. This command stops label feeding and makes the red LED flash if

the printer does not locate gap after feeding the length of one label plus one preset value.

Syntax

LIMITFEED n[,minpaper,maxgap]

English system (inch)

LIMITFEED n mm[,minpaper

mm,maxgap mm]

Metric system (mm)

LIMITFEED n dot[,minpaper

dot,maxgap dot]

Dot measurement

This command has been supported since V6.34 EZ.

Parameter

Description

The maximum length for sensor detecting

Minpaper

The minimum length of paper

Maxgap

The maximum length of gap

Note:

 The setting will remain resident in memory.

 For metric system, there must be a space between parameter n and mm.

 The default value is 10 inches when printer initializes.

 Since V6.76 EZ, the default value for TDP-225 series printer is 14 inches when printer

initializes.

 The setting of parameters “mimpaper” and “maxgap” are using for calibrating the

preprinted label. This parameter has been supported since V6.98.7 EZ.

Example

Sample code

 English system (inch)

LIMITFEED 12

TSC M23 Programming Manual

Other manuals for TSC M23