Ubee Interactive Setting Up and Connecting the UBC1303AB00
Ubee UBC1303AB00 Advanced Wireless Voice Gateway Subscriber User Guide • June 2017 15
3. Power on your PC. The PC must have an Ethernet network adapter or Ethernet port
and an Internet browser installed, such as Firefox or Internet Explorer. The following
browsers are supported:
For Windows 2000, XP, Vista, Windows 8, Windows 7, Google Chrome, Firefox
1.07 and higher, Internet Explorer v7 and above, Netscape.
For MAC OS X, 10.2, and higher: Firefox 1.07 and higher, Google Chrome, Safari
1.x and higher.
4. Connect the power adapter included in the product package into the POWER port on
the rear panel of the cable modem. Plug the power cord into the power adapter and
plug the other end into the power outlet.
5. Connect the Ethernet cable included in the product package to your computer’s
Ethernet port. Connect the other end to one of the 4 ETHERNET ports on the
UBC1303AB00.
6. Connect an analog telephone (if you will be using the device for telephone service) to
the TEL 1 or TEL 2 port on the back panel of the device. Use an RJ-11 telephone
cable (not supplied).
7. Validate the network connection using the device LEDs to confirm operations.
The POWER, DS, US, and ONLINE LEDs are solidly lit.
Refer to Understanding LED Behavior on page 6 for more information.
2.1.1 Wall Mount Installation
You can mount the UBC1303AB00 on a wall using the 2 mounting brackets on the side of
the device. Two round or pan head screws are recommended. See the figure below.
To mount the UBC1303AB00 on a wall:
1. Install the two screws horizontally on a wall 140mm apart. See the figure below.
Label
Size in Millimeters
(mm)
A 7.2 +/- 0.5
B 2.6 +/- 0.15
C 19.0 +/- 1.2
To Next Page
Loading...
Need help?
General
