Unify OpenStage 15 User Manual

94 Enhanced phone functions
CTI calls
Beep on auto-answer
Speakerphone mode automatically activates on your phone if you use a CTI ap-
plication such as Outlook to dial a number when Auto-answer is active. If Auto-
answer is not active, the phone rings first and you have to press the loudspeaker
key or lift the handset to set up the call. This setting also defines whether or not
incoming calls are automatically accepted. If the function is active, an alert beep
sounds when an incoming call is automatically accepted.
Information on the operation of the configured CTI application can be found in
the corresponding user guide.
z
You can also configure this setting via the web interface  Page 197.
Prerequisite: The option was programmed by your administrator.
N Press the key shown.
Select and confirm the option shown.
Select and confirm the option shown.
if nec.j Enter and confirm the user password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Settings
User
Configuration
Incoming calls?
CTI calls? f
AutoAnswer = No f
Yes l
AutoAnswer beep = No
Yes l
Save & Exit l

Unify OpenStage 15 Specifications

General

Brand	Unify
Model	OpenStage 15
Category	Telephone
Language	English