6.8 First setup of digital thermostat
Select thermostat control mode
If an external sensor is connected to the thermostat,
a control mode must be selected to accommodate the
extra functionality of the sensor.
NOTE!
If no button is pressed for about 60 seconds,
the current values will be saved and the
software exits to run mode.
1. Press and hold the OK button until the settings icon
and the numbers 00 is displayed in the top right
corner of the display (about 3 seconds).
2. Use the - and + buttons to change the numbers to
04 and press OK.
3. Current control mode is displayed (RT, RFT, RS or
RO).
4. Use the - and + buttons to change control mode
(see list below) and press OK.
RT = Room temperature
RFT = Room temperature with external floor sensor
(display of temperature only)
RS = Remote sensor
RO = Room temperature with remote outdoor
sensor
5. Press and hold the OK button, for about 3 seconds,
to exit the settings menu.
Setpoint temperature
The thermostat is delivered with a default setpoint of
21 °C.
The illustration below shows how to adjust the
thermostat temperature setpoint.
To adjust the thermostat temperature setpoint of the
current control mode:
1. Press the - or + button once.
The screen shows the current setpoint flashing.
T-166
T-167
T-168
2. Press the - or + button repeatedly to adjust the
setpoint temperature. It will change with increments
of 0.5.
When the new setpoint is set, the screen returns to
run mode after a few seconds, showing the room
temperature.
UK
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
31
UPONOR SMATRIX MOVE/MOVE PLUS
·
INSTALLATION AND OPERATION MANUAL
To Next Page
Loading...
Need help?
General
