Components of the thermostat:
The illustration below shows the thermostat and its
components.
A
D
B
C
E
Item Description
A Uponor Smatrix Wave Thermostat Public T-163
B Wall bracket
C Batteries (AAA 1.5 V)
D Mounting material
E Connection terminal
3.4 Accessories
Uponor offers a wide variety of accessories for use with
the standard portfolio.
B
A
D
E
C
NOTE!
Some of these accessories may also be
included in the system.
Item Component Description
A Attachment
options for
thermostats
T-163, T-166,
T-167, T-168
Table stand
B Screws
C Uponor Smatrix
Wallframe T-X
A-1XX
(wallframe T-X
A-1XX)
Wall frame for covering larger
area of the wall than original
back plate. Used at installation of
thermostats T-163, T-166, T-167,
T-168
D Uponor Smatrix
Move Sensor
Supply/Return
S-152
Supply/return sensor for use with
the controller
E Uponor Smatrix
Sensor Floor/
Remote S-1XX
(floor/remote
sensor S-1XX)
Floor/remote sensor for use with
thermostats T-163, T-166, T-167
and T-168
3.5 Functions
Uponor Smatrix Move/Move PLUS is used to control an
underfloor heating and/or cooling system in a house.
Uponor Smatrix Move
The controller calculates the supply temperature
using the outdoor temperature and a heating curve.
The calculated supply temperature is compared to
the measured supply temperature. If the measured
temperature differs from the calculated, the controller
adjusts the flow through the mixer valve to raise or
lower the supply temperature.
Uponor Smatrix Move PLUS
The controller calculates the supply temperature
using the outdoor temperature and a heating curve.
The calculated supply temperature is compared to
the measured supply temperature. If the measured
temperature differs from the calculated, the controller
adjusts the flow through the mixer valve to raise or
lower the supply temperature.
If a thermostat is present in the system, it is also used
to further adjust the flow to the reference room and to
reach the setpoint quicker.
As soon as the temperature measured at the thermostat
is lower (heating mode) or higher (cooling mode) than
the setpoint temperature, a demand to change the room
temperature is created and sent to the controller. The
controller will open the actuator according to current
operating mode and other settings. Once the set
temperature is reached, the actuator closes.
Heating and cooling curve
The heating and cooling curves for the Uponor Smatrix
Move/Move PLUS controller is shown in the diagram
below. The diagram shows the calculated supply
temperature, for each curve, at different outdoor
temperatures. The controller uses the selected curve
to operate the mixer valve, which in turn adjusts the
supply temperature to the system.
80
70
60
50
40
30
20
10
36 34 32 30 28 26 24 22 20 18 16 14 12 10 8642 -2 -4 -6 -8 -10-12-14-16-18 -200
0,2
0,4
0,6
0,7
0,8
1
1,2
1,5
To Next Page
Loading...
Need help?
General
